Class EF inverter design chart - Interactive tool
Chargement du petit SVG...
R = -
L = -
D (%) = -
P = -
L = -
D (%) = -
P = -
q = -
V0 = -
I = -
V0 = -
I = -
Chargement du SVG principal...
Reduced parameters
r :
-
x :
-
Zone :
-
p :
-
D :
-
q :
-
v :
-
Welcome to my interactive tool!
1/ Enter the values for VDC, F, and Cs above the circuit
2/ Click on the chart to set the operating point
3/ The waveforms will show up on the right, and the values for physical parameters related to that point will appear above the circuit! It’s magic! 🧙♂️
Tip: The VDC and I values above the circuit will help you read the waveforms better, the reduced parameters obtained by direct reading of the chart are gathered below.
⚠️ Caution: the results might get a bit off if the resistance r is too low — meaning if the operating point is too far to the left because the numerical resolution goes a little bit crazy in that case 😬